House General
Kitchen
Dishwasher
- Turn on and load
Press the On / Off button to turn the appliance on. Then load the baskets and add the specific dishwasher detergent. - Use of the Detergent
Put the tablet in its detergent container. Please use only an ‘All in One’ dishwasher tablet detergent. NO LIQUID OR POWDER DETERGENT IS ALLOWED. - Starting a Program
- Keep the appliance door ajar.
- Press the On / Off button to turn the appliance on. Verify that it is in program selection mode.
- Press the program selection button repeatedly until the indicator light of the program you want to set starts to flash.
- Close the appliance door to start the program.
- Opening the Door During Washing
When the door is open while a program is running, the equipment stops. This can affect energy consumption and program duration. After closing the door, the equipment will resume from the point where it was interrupted.
Note. If the door remains open for more than 30 seconds during the drying phase, the current program ends. This does not happen if the door is opened by the AutoOpen function. Do not try to close the appliance door within 2 minutes after AutoOpen automatically opens it, as this may cause damage to the equipment.
If the door is subsequently closed for another 3 minutes, the operating mode ends. - Cancellation of the Program
Press and hold the program selection button until the equipment enters program selection mode.
Check that there is detergent in the container before starting a new program. - Term of the Program
Once the program is finished, the indicator lights up.
Press the On / Off button or wait until the appliance enters standby mode. If you open the door before the standby mode is activated, the equipment will switch itself off automatically.